Please take the time to fully read the entire installation instructions before installing DashPac.
Configure Newer Ski DashPac.
Attention if you DashPac was purchased before Jan 1st 2019 and or has a 4 digit Serial number see Original DashPac setup below!
New DashPac Setup. This only Works on the newer Bosch Universal. 1. Go to the Depth display on your Ski. 2. Push the right hand side keypad down button once. This is AFR mode. 3. If the display in not reading a number between 10.0 and 22,2 or 88.8 push and hold the up button for 30 seconds. 4. Push the down button once. If the display in not reading a number between 10.0 and 22,2 or 88.8 repeat step 3. 5. If the DashPac is still not operating correctly push and hold the right hand side keypad down button until the display changes (Long Press) Displays 0.0 until you let go of the button then 1.0 6. Quickly use the up and down button to select one of the following. 1.0 Is for Dash Clusters with no decimal on the depth dispaly. 2.0 Is for Dash Clusters with a decimal on the depth display. 3.0 Is for the 2019 Cluster and allows Engine Temp to be displayed. 4.0 Is for the DashFlash. 7. A timer will time out and save the setting of the number that was displayed. 8. Congratulations your Unit is now reconfigured.
Original DashPac Setup.
This only Works on the newer Bosch Universal and Motec Universal. Email andy@DashPac.net to get the setting number you need to correctly configure your DashPac. (1 through 16) Please note we setup each unit before shipping but sometimes a change is needed for various reasons. Again normally this doesn't need to be done.
1. Install Key and click start button to turn on ski but don't start the ski. 2. Pull up the Depth/DashPac display on the screen. 3. With the ski NOT running push and hold the Trim down button for 30+ seconds till the screen changes. The button push it unreasonably long to prevent accidentally entering into the setup mode. 4. using the right hand side up down buttons click up or down until the number is shown that we emailed you.(see above) 5. with the correct number shown push set button. 6. Congratulations your Unit is now reconfigured. 7. If DashPac is still not displaying Correctly Email us for a resolution.