Please take the time to fully read the entire installation instructions before installing DashPac.
Install of Siemens and Bosch Depth Modules.
Locate your Depth sensor. Near the sensor is a plug in for the sensor. Bosch skis have a 6 pin DT connector and Siemens have a 4 pin DT connector. Unplug this connector. Reroute the ski side of this connection and wires to the front of the ski. Plug this into the DashPac Depth Module. Mount the DashPac Depth module. Route the other longer wires from the Depth Module back to the Depth sensor and connect them. Secure all wires nice clean way to avoid physical Damage from hot or moving parts.
If not already done, install the main DashPac Module per separate Instructions.
When everything is installed and put back together, On Bosch Skis, Push and hold the down button (Same button as AFR) With a few seconds of holding the down button the DashPac display will Show you Depth on the screen. To exit the Depth mode simply click the up button to see Boost. Then you can click down to see AFR. Push and hold the down for a few seconds to see Depth.
On Siemens Skis,
We include a 3 position Switch on the Main DashPac Module. The Middle position Shows you depth. the up/Down positions show Boost/AFR.