DashPac Installation
2003-2010 Siemens ECU DashPac
Please take the time to fully read the entire installation instructions before installing DashPac.
Install Siemens Version of DashPac
1. Plug in Buds or Candoo and Activate the Depth feature. (DashPac module must be unplugged for this to work). Not Included.
2. Locate the 6 pin diagnostic connector near the battery.
3. Unplug the connector from the cap.
4. Plug the 2 ends of the DashPac module into the diagnostic connector and the cap.
5. Mount the DashPac Module.
6. Route the switch to the location of your Choice. (Typically people like to mount the switch next to the Dress Post (KEY) )
7. Mount the switch.
8. Install the AFR Sensor. (There are several ways to install the sensor we leave this up to you).
9. Route the AFR sensor wire to the AFR sensor and plug it in.
10. install the key (dont start). on 2003-2005 skis scroll through the menu till you find depth.
This is your new DashPac screen! push the button to toggle between Boost and AFR Display.
If the Display reads around 14.0-15.0 and doesn't change with the engine running the o2 sensor is bad and needs to be replaced.
If the display is reading slow and reacts to changing AFR slowly the sensor is going bad.
Another issue we see is water on the sensor. Water will kill the AFR sensor very quickly, and can give very strange AFR readings.
If you install your Sensor near a water jacketed Exhaust, Make sure the water jacket is pressure tested for leaks.
The Sensor needs to be installed up stream of where the water mixes with the exhaust. (In the dry exhaust)
AFR sensors are NOT warrantied by DashPac! Replacement Sensors can be found in our Store.
2. Locate the 6 pin diagnostic connector near the battery.
3. Unplug the connector from the cap.
4. Plug the 2 ends of the DashPac module into the diagnostic connector and the cap.
5. Mount the DashPac Module.
6. Route the switch to the location of your Choice. (Typically people like to mount the switch next to the Dress Post (KEY) )
7. Mount the switch.
8. Install the AFR Sensor. (There are several ways to install the sensor we leave this up to you).
9. Route the AFR sensor wire to the AFR sensor and plug it in.
10. install the key (dont start). on 2003-2005 skis scroll through the menu till you find depth.
This is your new DashPac screen! push the button to toggle between Boost and AFR Display.
If the Display reads around 14.0-15.0 and doesn't change with the engine running the o2 sensor is bad and needs to be replaced.
If the display is reading slow and reacts to changing AFR slowly the sensor is going bad.
Another issue we see is water on the sensor. Water will kill the AFR sensor very quickly, and can give very strange AFR readings.
If you install your Sensor near a water jacketed Exhaust, Make sure the water jacket is pressure tested for leaks.
The Sensor needs to be installed up stream of where the water mixes with the exhaust. (In the dry exhaust)
AFR sensors are NOT warrantied by DashPac! Replacement Sensors can be found in our Store.
